Screen type 1 Screen type 2 Cause Solution (Reference)
––
l
The
keyless operation key is not
detected.
l
Insert the keyless operation key
into the key slot in the glove box.
Refer to “If the keyless operation
key is not operating properly” on
page 1-17.
––
l
You have forgotten to remove
the keyless operation key from
the key slot in the glove box.
l
Remove the keyless operation
key from the key slot in the
glove box.
––
l
The steering wheel is locked.
l
Press the engine switch.
Refer
to “Steering wheel lock”
on page 1-14.
––
l
The engine is stopped and the se-
lector
lever is in a position other
than the “P” (PARK) position.
l
On vehicles with CVT, move the
selector lever to the “P” (PARK)
position to put the operation
mode in OFF.
––
l
The
driver’s door is opened with
the steering wheel unlocked.
l
Refer to “Steering wheel lock”
on page 1-14.
––
l
There
is a fault in the electrical
system.
l
Immediately stop the vehicle in a
safe place. We recommend you
to consult a MITSUBISHI
MOTORS Authorized Service
Point.
Instruments and controls
3-29
3
To Next Page
Loading...
