NOTE
l
When
the following operation is performed
with the operation mode in OFF, the steering
wheel is locked.
• Open or close one of the doors (except
the tailgate).
• Lock all doors and the tailgate with the
keyless entry system or the keyless opera-
tion function.
l
When the steering wheel does not unlock,
the warning will be displayed on the informa-
tion screen in the multi-information display.
Press the engine switch again while moving
the steering wheel slightly.
Starting and stopping the engine
E00306900395
Tips for starting
l
The
operation mode can be in any mode to
start the engine.
l
The
starter motor will be turning for up to ap-
proximately 15 seconds if the engine switch
is released at once. Pressing the engine
switch again while the starter motor is still
turning will stop the starter motor. The start-
er motor will be turning for up to approxi-
mately 30 seconds while the engine switch is
pressed.
If the engine does not start, wait for a while
and then attempt to start the engine again. Try-
ing repeatedly with the starter motor still run-
ning will damage the starter mechanism.
l
[Diesel-powered vehicles]
While the vehicle is stationary with the
clutch pedal fully depressed, the engine revo-
lutions do not rise to over 3,000 rpm in order
to protect the engine even if the accelerator
pedal is depressed.
WARNING
l
Never
run the engine in a closed or poor-
ly ventilated area any longer than is nee-
ded to move your vehicle in or out of the
area. Carbon monoxide gases are odour-
less and can be fatal.
CAUTION
l
Never attempt to start the engine by push-
ing or pulling the vehicle.
l
Do not run the engine at high rpm or
drive the vehicle at high speed until the en-
gine has had a chance to warm up.
Starting the engine (petrol-powered vehicles)
E00307000478
The starting procedure is as follows:
1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal (M/T).
NOTE
l
On vehicles with the Auto Stop & Go
(AS&G) system, the starter will not operate
unless the clutch pedal is fully depressed
(Clutch interlock).
5. On vehicles equipped with M/T, place the
gearshift lever in the “N” (Neutral) position.
On vehicles equipped with CVT, make sure
the selector lever is in the “P” (PARK) posi-
tion.
To Next Page
Loading...
Need help?
General
