Each time the door and tailgate unlock function is
set, a chime will sound to tell you the condition of
the door and tailgate unlock function.
Number of
chimes
Condition
One chime All doors and the tailgate unlock
Two chimes Driver’s door unlock only
1. Put the operation mode in OFF.
2. Place the combination headlamps and dipper
switch in the “OFF” position, and leave the
driver’s door open.
3. Press and hold the LOCK switch (1) for 4 to
10 seconds and then also press the UNLOCK
switch (2) during this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of press-
ing the LOCK switch in step 3.
NOTE
l
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the ad-
justment. Refer to the separate owner’s man-
ual for details.
Procedure for replacing the remote control switch
battery
E00309600061
1. With
the MITSUBISHI mark facing you, in-
sert the cloth-covered tip of a straight blade
(or minus) screwdriver into the notch in the
case and use it to open the case.
NOTE
l
Be
sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the case, the transmitter may come
out.
2. Remove the old battery.
3. Install a new battery with the + side (A) up.
4. Close the case firmly.
5. Check the keyless operation function to see
that it works.
NOTE
l
You may purchase a replacement battery at
an electric appliance store.
l
A MITSUBISHI MOTORS Authorized Serv-
ice Point can replace the battery for you if
you prefer.
CAUTION
l
When
the remote control switch case is
opened, be careful to keep water, dust,
etc. out. Also, do not touch the internal
components.
Locking and unlocking
1-20
1