The settings mode can be toggled by press-
ing
the UNLOCK switch. The mode can be
confirmed from the number of times the buz-
zer sounds.
Number of
times the buz-
zer sounds
Security alarm settings mode
1 Alarm inactive
2 Alarm active
6. Any
of the following operations can be used
to terminate the system settings change mode.
l
Releasing the windscreen wiper and wash-
er switch.
l
Closing the driver’s door.
l
Inserting the key into the ignition switch
(except for vehicles equipped with the key-
less operation system).
l
Putting the operation mode in ON or
ACC. (vehicles equipped with the key-
less operation system)
l
Placing the lamp switch in any position
other than “OFF”.
l
Allowing 30 seconds to pass without mak-
ing any changes to the settings.
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700620
Follow the procedure below to set the system to the
system armed mode.
1. Except
for vehicles equipped with the key-
less operation system, remove the key from
the ignition switch. For vehicles equipped
with the keyless operation system, put the op-
eration mode in OFF.
2. Exit the vehicle and close all of the doors, tail-
gate and bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver’s or
front passenger’s door lock/unlock switch
(B), or the tailgate LOCK switch (C) in order
to lock all the doors and the tailgate.
To Next Page
Loading...
Need help?
General
