Mitsubishi City Multi Series PLFY-P08NCMU-E - Page 13

13
(RED)
(RED)
MODELS
P08
P12
P15
<Fig.1>
ON
OFF
123456
ON
OFF
123456
ON
OFF
123456
SW2
Power supply for MA-Remote controller on → Lamp is lit.
Main power supply(Indoor unit:208-230V) power on → Lamp is lit.Main power supply
Power supply for
MA-Remote controller
LED2
(RED)
LED1
(RED)
Mark Meaning
LED on indoor controller board for service
Function
Notes:
1. At servicing for outdoor unit, always follow the wiring diagram of outdoor unit.
2. In case of using MA-Remote controller, please connect to TB15. (Remote controller wire is non-polar.)
3. In case of using M-NET, please connect to TB5. (Transmisson wire is non-polar.)
4. Symbol [S] of TB5 is the shield wire connection.
5. Symbols used in wiring diagram above are, : terminal block, :connecter.
6. The setting of the SW2 dip switch differs in the capacity. For the detail, refer to Fig.1.
7. Use copper supply wire.
The black square (■) indicates a switch position.
PLFY-P08NCMU-ER2.TH PLFY-P12NCMU-ER2.TH PLFY-P15NCMU-ER2.TH
PLFY-P08NCMU-ER3.TH PLFY-P12NCMU-ER3.TH PLFY-P15NCMU-ER3.TH
OCH410D