EXHAUST MANIFOLD AND TURBOCHARGER
TSB Revision
INTAKE AND EXHAUST
15-20
REMOVAL SERVICE POINTS
.
<<A>> TURBOCHARGER COMPRESSOR
BRACKET REMOVAL
AC710947
AC
MB992274
Turbocharger
compressor
bracket
Turbocharger
air inlet fitting
Use special MB992274 to remove the turbocharger compres-
sor bracket mounting bolt (cylinder block side).
.
<<B>> WASTE GATE ACTUATOR REMOVAL
AC710816
AB
Adjusting rod
Lock nut
CAUTION
Never loosen the locking nuts and adjusting rod of the
waste gate actuator.
.
<<C>> TURBOCHARGER OIL FEED TUBE
REMOVAL
CAUTION
Take care not to allow foreign objects to get into the oil
passage hole of the turbocharger assembly after the turbo
-
charger oil feed tube is removed.
INSTALLATION SERVICE POINTS
.
>>A<< TURBOCHARGER INSTALLATION
1. Clean the turbocharger oil feed tube, turbocharger water
feed pipe and turbocharger water return pipe fitting, the
inside of eye bolts, and individual pipe for clogs.
CAUTION
Take care not to allow foreign objects to get into the turbo-
charger.
2. Clean or use compressed air to remove any carbon particles
stuck to the oil passage of the turbocharger.
3. Refill new engine oil at the turbocharger oil feed tube fitting
hole of the turbocharger.
.
To Next Page
Loading...
Need help?
General
