Mitsubishi FDC121KXZEN1-W - Page 289

-
287
-
'20 • KX-T-373
6.
To remove the temperature sensors (example"Thi-R1")
(1) Remove the lid of control box.(See No.1)
(2) Disconnect the temperature sensors connector(CNNx).
(3) Remove the drain pan.(See No.3)
(4) Pull out the temperature sensors "Thi-R1" from the sensor holder.
7.
To remove the heat exchanger assembly
(1) Remove the drain pan.(See No.4)
(2)
Remove 2 pipe lid fixing screws then remove the pipe lid.(
□
mark)
(3)
Remove the fan motor wiring from clip and grommet.(
←
mark)
(4)
Remove 3 heat exchanger assembly fixing screws then remove the heat exchanger assembly.(
○
mark)
8.
To remove the Electronic Expansion Valve (EEV)
(1) Remove the heat exchanger assembly.(See No.7)
(2)
Remove the damper sealant from EEV.
(3)
Remove the coil of EEV by pull out on the top.
(4)
Remove welded part of EEV by welding.(
○
mark)
PJA012D792A
PROCEDURE & PICTURES
coil of EEV
EEV
General view