-
292
-
'20 • KX-T-373
●
Read these "Precautions for safety" carefully before starting disassembly work and do it in the proper way.
●
When disassembling, be sure to turn off the power. When disassembling the electrical components, check the electrical wiring diagram.
●
The electrical components are under high voltage by the operation of the booster capacitor.
Fully discharge the capacitor before commencing a repair work. Failure to observe this warning could result in electric shock.
●
These contents are an example. Please refer to a similar part of actual unit.
1. To remove the corner lid
(1) Remove the inlet grille.
(2) Pull the corner lid toward the direction
indicated by the arrow and remove it.
(The four corner lids are the same way.)
2. To remove the louber motor (LM)
(1) Remove the corner lid.(See No.1)
(2) Remove the louber motor fixing screw
3. To remove anti draft motor (AM)
(1) Remove the corner lid.(See No.1)
(2) Remove 2 gear box fixing
screws and remove it.(○ mark)
1. To remove the corner lid
(1) Remove the inlet grille.
(2)
Remove the screw(← mark), pull the corner
lid toword the direction indicated by the
(The four corner lids are the same way.)
2. To remove the louber motor (LM)
(1) Remove the corner lid.(See No.1)
(2) Remove 2 louber motor fixing screws
3. To remove anti draft motor (AM)
(1) Remove the corner lid.(See No.1)
(2) Remove 2 gear box fixing
screws and remove it.(○ mark)
1. To remove the louber motor (LM)
(1) Remove the cover fixing screw and
(2) Remove the cam fixing screw and
(3) Remove 2 louver motor fixing screws
To remove the limit switch (LS)
(1) Remove the cover fixing screw and
Remove 2 limit switch fixing screws
1. To remove the corner lid
(1) Take off the corner panel fixing hooks
by a flathead screwdriver and remove it.
2. To remove the louber motor (LM)
(1) Remove the corner lid.(See No.1)
(2) Remove 2 louber motor fixing screws
FDT series
FDTC series
FDTS・FDTQ series
Corner lid
Corner lid
FDTW series
(4) Panel
PSC012D109A
To Next Page
Loading...
