-
302
-
'20 • KX-T-373
PJF000Z634
'20 • PAC-T-352
-
47
-
(1) Specification
5. WIRELESS KIT
FDTC series(RCN-TC-5AW-E3)
Refrigerant pipe
Drain pipe
Notes
(1)Receiver must be installed to the position as shown.
(2)Two LR03 AAA dry cell batteries for remote
control are enclosed.
(3)See spec sheet of "Wireless remote control"
about remote control.
Do not install the wireless kit at the following places
in order to avoid malfunction.
Installation of wireless kit
(1)Places exposed to direct sunlight
(2)Places near heat-generating devices
(3)High humidity places
(4)Hot surface or cold surface
enough to generate condensation
(5)Places exposed to oil mist or steam directly
(6)Uneven surface
(7)Places affected by the direct airflow of the AC unit
Setting switch on PCB
SW3
SW4
SW2
SW1
Receiver master/
slave setting
Buzzer
Auto restart
ON
:
Normal
OFF
:
Remote
ON
:
Master
OFF
:
Slave
ON
:
Valid
OFF
:
Invalid
ON
:
Valid
OFF
:
Invalid
Default setting: mark
Prevents interference
during multiple setting
RUN
CHECK
TIMER
Receiver
RUN
CHECK
TIMER
PCB
Installation position of PCB
(8)Places where the receiver is influenced
by fluorescent lamp or sunlight
(9)Places where the receiver is affected by infrared
rays of any other communication devices
(10)Places where some object may obstruct the
communication with the remote control
139
139
167
60
24
65
75
23 45
32.5
Remote control
Remote control holder
Wireless remote control's operable area
Standard reachable area of the signal
[condition] Illuminance at the receiver:300lux
ehtfom1nihtiwdellatsnisignithgilonnehW（
receiver in an ordinary office）
Correlation between illuminance at the receiver and
reachable area of the signal in a plain view.
The drawing in the right shows the correlation between the
reachable area of the signal and illuminance at the receiver
when the remote control is operated at 1m high under
the condition of ceiling height of 2.4m.
When the illuminance becomes double,
the area is narrowed down to two thirds.
Installation tips when several receivers are installed close
to one another Minimum distance between the indoor units
which can avoid cross communication is 5m under the
condition of 300lux of illuminance at the receiver.
m1nihtiwdellatsnisignithgilonnehW（
of the receiver in an ordinary office）
Unit:mm
1
2
3
Receiver
Installation position of wireless kit
(2) FDTC series(RCN-TC-5AW-E3)
(a) Specification
To Next Page
Loading...
