-
323
-
PJF000Z509
'20 • PAC-T-352
-
56
-
(1) Specification
6. MOTION SENSOR KIT
FDTC series(LB-TC-5W-E)
Installation of motion sensor kit
(1)Places exposed to direct sunlight
(2)Places near heat-generating devices
(3)High humidity places
(4)Hot surface or cold surface
enough to generate condensation
(5)Places directly exposed to oil mist or steam
(6)Places affected by the direct airflow of the
indoor unit
(7)Places where the motion sensor may be influenced
by fluorescent lamp or sunlight
(8)Places where the motion sensor may be affected by
infrared rays of any other communication devices
(9)Places where some object may obstruct the
motion sensor
(10)Places where there may be impact on
the motion sensor
(11)Places with strong radio wave or static electricity
(12)Dusty place where the motion sensor
lens may become tainted or be damaged
The detectable area
Note
(1)Motion sensor must be installed
to the position as shown.
Installation position of motion sensor kit
Motion
sensor
Refrigerant pipe
Drain pipe
Motion sensor kit
139
139
Unit:mm
Do not install the motion sensor kit at the following
places in order to avoid malfunction.
(2) FDTC series(LB-TC-5W-E)
(a) Specification
To Next Page
Loading...
