-
334
-
②
Remove the screw at the side of the motion sensor
and slide the upper case in the direction of the arrow.
(The same as
②
of Option (A))
③
Pull the wiring of the motion sensor.
(The same as
③
of Option (A))
④
Pass the relay wiring through the hole on the lower
case from switch box.
⑤
Fix the lower case to switch box using the installing
hole (1 place).
Wiring connection in the control box of indoor unit
Lower case
Fix to the
switch box
Installing hole
Installing hole
Switch box installing hole
Installing hole
Install to the
ceiling plane
Lower case
Switch box
CAUTION: Attached wirings to the motion sensor vary depending on the model of the indoor unit.
Make sure your model before installing.
<In case of the CnL connector is on the indoor unit PCB (FDT/FDK/FDTC)>
①
Connect the same color to the relay wiring (prepare on site) and the attached wiring <1>.
②
Remove the control box cover from the indoor unit.
③
Connect CnL connector (3P, black) to the PCB.
⑥
Connect the same color to the relay wiring (prepare
on site) and the wiring of motion sensor.
(The same as
⑥
of Option (A))
⑦
Place the connecting part between switch box and
the hole of the lower case through passed the wiring
at step
④
.
⑧
Taking care not to pinch the wirings, slip the upper
case into the lower case, and tighten the screws.
(The same as
⑨
of Option (A))
Relay wiring
(prepare on site)
Connect
wirings with the
same colors
White
Red
Black
White
Red
Black
Attached wiring to
motion sensor <1>
CnL connector
(3P, black)
To Next Page
Loading...
