'17 • KX-T-264
②
Install Display-Assy on Indoor unit
(a) Remove the control cover, and then louver wiring can be removed to CnJ1 on the PWB.
(b) Remove the louver wiring hanging on display holder.
(c) Remove the latches of display holder and then display holder can be removed.
(Type 15 - 56 : 4 latches, Type 71, 90 : 6 latches)
* Please use slotted screwdriver etc when remove the latches of display holder.
(d) Fix the latches of Display-Assy and then Display-Assy can be installed.
(Type 15 - 56 : 4 latches, Type 71, 90 : 6 latches)
(e) Hang on the louver wiring to the Display-Assy.
(f) Connect the louver wiring to CnJ1 on the PWB, and fix the control cover.
③
Fix wiring and install the Control-Assy on Indoor unit.
(a) Fix the terminal of the wiring assy (for X, Y) on the terminal block of the indoor unit. (No polarity)
(b) Route the wiring as shown in
(c) Connect relay connectors of the Display-Assy and the Control-Assy.
(d) The
place of wireless interface is refer to the following
In the case of Left-hand-side piping
CNJ1
How to install the receiver (continued)
Type 15 - 56 Type 71, 90
Type 15 - 56
Type 71, 90
Type 15 - 56 Type 71, 90
Latch
Latch
Latch
Latch
Display holder
Display holder
CNJ1
Display-Assy
Relay connector
Wiring
(for X, Y)
Wiring (for X, Y)
Display-Assy
Display-Assy
Control-Assy
Display-Assy
Relay connector Control-Assy
Control-Assy
Control-Assy
CnJ1
CnJ1
③
–
111
–
To Next Page
Loading...
