Mitsubishi FR-BU2-1.5K - Resistor Unit Dimensions

53
OUTLINE DIMENSION DRAWINGS
(2) Resistor unit
<GRZG type>
• The maximum temperature rise of the brake resistors is approximately
200deg or more. For wiring, therefore, use heat-resistant wires (such as
fiber-glass braided wires) or cover the wires with silicone tube. Also perform
wiring so that the wires do not make contact with the resistors.
Also, separate a component, which is low in heat-resistant property, at least
15 to 20cm from the resistors.
Model
W W1 W2 H H1 H2 D D1 d
GZG300W 335 309 274 78 42 40 40 9.5 5.5
GRZG200 306 287 266 53 33 22 26 6 5.5
GRZG300 334 309 274 79 47 40 40 9.5 5.5
GRZG400 411 385 350 79 47 40 40 9.5 5.5
D1
D
H2
H
Terminal
W1
W
d hole
H1
W2
(Unit: mm)
Brake resistor
IV wire
Heat-resistant
wire
Cover the wires
with silicone
tubing
Separate a component,
which is low in heat-
resistant property,
15cm to 20cm or more. *
* When it is inevitable to place a component, which is low in the heat-resisting property, in
the vicinity of the resistors, mount a temperature sensor to the component with low heat-
resisting property and make up a sequence which shuts off power of the inverter input side
by the temperature sensor signal. For the temparature sensor, contact the manufacturer.