REASSEMBLY OF BASIC ENGINE
7-21
4.11 Adjusting valve clearance
Adjust the valve clearance.
For adjusting procedures, refer to "Adjustment and
Operation."
Adjusting valve clearance
Timing mark
4.12 Installing rocker cover
(1)
Make sure that the gasket is firmly installed into the
rocker cover.
(2) Tighten the rocker cover mounting nuts to the specified
torque.
Installing rocker cover
4.13 Installing torque spring set
For installing procedures of the torque spring set, refer to
item "Installing Fuel System."
Mark on gear
case side
TDC mark on crankshaft
pulley side
Model Ignition order Rotation angle
.
.
q
q
Tightening torque
4.9 to 6.9 N㨯m
{0.5 to 0.7 kgf㨯m}
[3.6 to 5.1 lbf㨯ft]
To Next Page
Loading...
