9
MICROPROCESSOR CONTROL
32
WIRELESS REMOTE CONTROLLER
Once the operation mode are set, the same operation mode
can be repeated by simply turning the
OPERATE/STOP(ON/OFF) button ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, 3-minute time delay will operate
to protect system from overload and compressor will not
restart for 3 minutes.
9-1. “I FEEL CONTROL” ( ) OPERATION
(1) Press OPERATE/STOP(ON/OFF) button on the
remote controller. OPERATION INDICATOR lamp of
the indoor unit turns on with a beep tone.
(2) Select “I FEEL CONTROL”
() mode with the
OPERATION SELECT button.
(3) The operation mode is determined by the room tem-
perature at start-up of the operation.
ON/OFF
FAN
TOO
WARM
TOO
COOL
VANE
MODE
STOP
START
HR.
MIN.
I FEEL
COOL
HEAT
DRY
RESET CLOCK
OPERATION SELECT button
FAN SPEED CONTROL button
OFF-TIMER button
HR. button
MIN. button
(TIME SET button)
ON-TIMER button
RESET button
VANE CONTROL button.
CLOCK SET button
ON/OFF
TOO
COOL
PM
AM
TOO
WARM
Signal transmitting section
Operation display section
OPERATE /STOP
(ON /OFF)button
TEMPERATURE buttons
Example
Previous operation
COOL mode of
“I FEEL CONTROL”
or COOL mode
● Once the mode is fixed, the mode does not change by
room temperature afterwards.
● Under the ON-TIMER ( ) operation, mode is
determined according to the room temperature at set
time the operation starts.
● When the system is stopped with the
OPERATE/ STOP(ON/OFF) button on the remote con-
troller, and restarted within 2 hours in “I FEEL CON-
TROL”
() mode, the system operates in previous
mode automatically regardless of the room tempera-
ture.
Example
Previous operation
COOL mode of
“I FEEL CONTROL”
or COOL mode
When the system is restarted after 2 hours and more,
the operation mode is determined by the room temper-
ature at start-up of the operation.
Restart
COOL mode of
“I FEEL CONTROL”
Restart
COOL or DRY or
HEAT mode of “I
FEEL CONTROL” that
is determined by room
temperature at start-up
of the operation.
Indication
Operation state
Difference
between set
temperatuer
and room
temperature
This shows that the air
conditioner is operating
to reach the target temp-
erature.
Please wait until the
target temperature is
obtained.
This shows that the
room temperature is
approaching the target
temperature.
lighted
not lighted
Approx. 2 :
or more
Approx. 2 :
or less
Operation Indicator
OPERATION INDICATOR
lamp
The operation indicator at the right side of the indoor
unit indicates the operation state.
MCFH-13NV - MCFH-18NV -
MCFH-24NV -
E3
E3E4
Mode
COOL mode of
"I FEEL CONTROL"
DRY mode of
"I FEEL CONTROL"
HEAT mode of
"I FEEL CONTROL"
Initial room temperature
25: or more
23:to 25:
less than 23:
INDOOR UNIT DISPLAY SECTION
MUCFH-13NV - MUCFH-24NV -
MUCFH-18NV -
E3
E3E4
OB267--2.qxp 01.4.13 1:01 PM Page 32
To Next Page
Loading...
