VIII
(5) Peripheral devices
1) Use a no-fuse breaker and magnetic contactor that comply with the EN/IEC Standards
described in Chapter 7 Peripheral Devices.
2) The wires sizes must follow the conditions below. When using other conditions, follow Table 5
of EN60204 and the Appendix C.
• Ambient temperature: 40°C
• Sheath: PVC (polyvinyl chloride)
• Install on wall or open table tray
(6) Servomotor
Contact Mitsubishi for the outline dimensions, connector signal array and detector cable.
(7) Others
Refer to the EMC INSTALLATION GUIDELINES (IB (NA) 67303) for other EMC Directive
measures related to the servo amplifier.
To Next Page
Loading...
Need help?
General
