7
¡ AUTO
The unit maintains the humidity level by
automatically controlling airflow and operating
intermittently as necessary. All you have to do is set
the humidity level.
¡ The unit turns off when current humidity
decreases past the set humidity level, and
restarts when the level is exceeded.
¡ The unit operates for 6 minutes continuously
regardless of the humidity level immediately after
turning the power on.
Frequent use of exits and room size/conditions
may cause the humidity to not reach the set
level.
<
To view set humidity level/ To set humidity level
>
¡
Pressing the button once displays
the set humidify level with the
indicator. After 3
seconds, the display
returns to the current
humidity display.
¡
Pressing HUMIDITY
SELECTION while is
displayed sets the
humidity level. Each time the button
is pressed, the humidity setting
changes.
¡ AIR PURIFIER
The unit cleans the air by passing it through the photocatalytic filter. The dehumidifying function is disabled.
∞ The air passes through the photocatalytic filter in all modes, cleaning the air even if the air purifier
lamp is not lit.
∞ Cigarette smoke and toxins found in smoke, such as carbon monoxide, cannot be removed with this
filter.
Information
Information
Press
Press
again
¡ Swing louvre function (how to read the swing monitor)
The louvre can be made to swing. Select from the 4 possible settings to suit the purpose.
Press
¡ Starts swing operation.
¡ The swing monitor is displayed.
The swing operation stops when the
power cord is unplugged.
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
Stop swing
operation
WIDE
UPWARD
REAR
With each
press of the
button
Stop the louvre in the vertical position when using the unit against a wall. Blowing air at the wall may
cause staining.
Note
∞ The level of noise emitted from the unit varies according to the angle of the air-flow.
∞ The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start
moving again.
∞ If the louvre is knocked out of the desired angle, readjust by following the above steps.
Information
To Next Page
Loading...
Need help?
General
