Mitsubishi Mr.Slim MFZ-KA09NA - Removing Horizontal Vane Motor; Removing Indoor Fan Motor (Upper)

32
OPERATING PROCEDURE PHOTOS
Photo 7
4. Removing the horizontal vane motor unit
(1) Remove the panel. (Refer to 1.)
(2) Remove the screws of the horizontal vane motor unit and
pull out the horizontal vane motor unit. (See Photo 6.)
(3) Disconnect the connector from the horizontal vane motor
unit.
Photo 6
5. Removing the indoor fan motor (upper)
(1) Remove the panel. (Refer to 1.)
(2) Remove the electrical box. (Refer to 3.)
(3) Remove the nozzle (upper). (See Photo 7.)
(4) Unhook the water cover from the catches and remove the
water cover. (See Photo 7.)
(5) Removing the screw of the motor band, and then the motor
band. (See Photo 8.)
(6) Remove the line flow fan and the indoor fan motor (upper)
from the box.
Photo 8
Screw of the horizontal
vane motor unit
Water cover
Screw of the motor band
Nozzle <Upper>
OBH568A