Mitsubishi Mr.Slim PEA-M140HAA - Installing the Unit

5
5. Installing the unit
5.1. Moving the unit to ceiling space
(1)Whenthefanunitdoesnotneedtobeseparatedfromthecoilunit
①
Bring the indoor unit to an installation site as it is packed.
②
To hang the indoor unit, use a lifting machine to lift and pass through the hanging bolts. [Fig. 5-1-1]
[Fig. 5-1-1]
Ⓐ
Ⓑ
Ⓐ
Unit body
Ⓑ
Lifting machine
(2)Whenthefanunitneedstobeseparatedfromthecoilunit
①
Bring the indoor unit to an installation site as it is packed.
②
 Beforeseparatingthefanunitfromthecoilunit,removetheinletangeandthecontrolboxcovertoremovethecableoftheheatexchangerthermistor.[Fig. 5-1-2]
[Fig. 5-1-2]
Coil unit
Fan unit
Inlet flange
③
Removetheconnector(CN44)ofthethermistorcablefromthecircuitboard,threadthethermistorcablethroughtherubberbushofthecontrolboxandtheconnection
ange,andplacethethermistorintheconnectionange.[Fig. 5-1-3]
[Fig. 5-1-3]
CN44