EasyManua.ls Logo

Mitsubishi MSZ-YK12VA-H1 - Move EyeControl Operation

Mitsubishi MSZ-YK12VA-H1
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
MOVE EYE CONTROL OPERATION...Sensible temperature
The proceed of the unit’s temperature control is a gerneral temperature control proceed, that accord to the temperature of wall,
oor and room measured by MOVE EYE sensors (MOVE EYE control operation).
Starting MOVE EYE control
MOVE EYE control operation is activated when MOVE EYE button is pressed with a thin stick in manual COOL or manual HEAT mode.
MOVE EYE control operation is activated when the remote controller is rst used following replacement of the batteries or resetting of the remote
controller.
Note:
Cancelling MOVE EYE control
MOVE EYE control operation is canceelled when MOVE EYE button is pressed with a thin stick once again.
If the conditioner is turned OFF without cancelling MOVE EYE control operation, MOVE EYE control operation is activated the next time the air
conditioner is turned ON.
Note:
Approx 150 degrees
MOVE EYE control operation
The sensors constantly measure the room and oor/wall tempera-
tures to automatically adjust to the set temperature by estimating
the temperature actually perceived by a person inside the room
("sensible temperature").
Advantages:
The air inside the room is conditioned quickly to a comfortable
condition.
The room will not become too cold or hot even when the air
conditioner is kept on for a long period.
Humidity
Approx 30%
Approx 20%
Approx 50%
Room/air temperature
Wall/oor temperature
Advantages of i-see
Sensible
temperature
Floor
temperature
Wall
temperature
Room
temperature
MOVE EYE sensor
When AREA setting is not activated, the sensing range of MOVE EYE Sensor differs depending on the installation location of the air-conditioner.
Installation
opsition
Installation at left
Installation at center
Installation at right
Left Center Right
Image of sensing
range
Driection of sensor
Refer to the description for slide switch setting. (Page 30)
Install the front panel correctly after being removed for maintenance or service so that the oor/wall temperatures can be measured correctly.
When cancel MOVE EYE control, the gerneral temperature control proceed will instead.

Related product manuals