112
Check method of power circuit board
Is the voltage of main incoming power
208/230 V AC ±10%?
• Check the breaker and power supply.
Is the voltage of CNAC (RED) on
multi controller circuit board
208/230 V AC ±10%?
• Check wiring.
• Replace power circuit board.
Is the voltage of CNDC(PNK) on multi
board 290–350 V DC?
•
Check wiring.
•
Check power circuit board.
•
Retry after the temperature of the PTC1,2
drops to 257°F[125°C] or less
Note:
To check the voltage of the parts on this board with a tester is difficult due to its location.
Test points are limited.
Yes
Yes
Yes
Yes
No
No
No
No
Is the voltage between M1 and M2 on
TB3 (M-NET transmission) 24–30 V DC?
• Check wiring.
• Check M-NET power circuit board.
No
Turn off the incoming power supply
and check the resistance of PTC1,2 on
the Power circuit board.
PTC1,2 = open ?
Yes (open)
•Replace Noise filter board and check
52C-relay,wiring,power circuit board .
•
Check wiring.
•
Check model setting switch SW4 on the
multi controller board.
•
Replace power board.
No
(normal)
Power circuit board check
Normal
Yes
Is the voltage of the compressor
(U-V, U-W and V-W) balanced?
1
3
CNAC
(RED)
1
Multi controller
circuit board
M-NET power
circuit board
52C
(relay)
PTCs
208/230 V AC
± 10%
Multi controller circuit board
CN2 (RED)
CN52 (RED)
13V DC
GND
16V
16V
GND(16V)
GND(18V)
18V
Signals
Signals
7
6
5
4
3
2
1
1
3
52C relay
drive signal
Power supply for
Inverter gate drive
Power supply for
PAM gate drive
L1
L2
TB1
208/230 V AC
±10%
3
5
CN1
(WHT)
COMP
U-V 10–180 V AC
V-W 10–180 V AC
W-U 10–180 V AC
CNDC
(PNK)
290–350 V DC
GND
1
3
Power suppl
To Next Page
Loading...
