139
8-12. SELECTING FUNCTIONS USING THE REMOTE CONTROLLER
Each function can be set as necessary using the remote controller. The setting of function for each unit can only be
done by the remote controller. Select function available from the <Table 1> .
(1) Functions available when setting the unit number to 00
Note that the functions in the table below are available only when P-series indoor unit and the wired remote controller is used.
<Table 1> Function selections
Meaning of "Function setting"
Mode02:indoor temperature detecting
No.
Indoor temperature(ta)=
No.1
Average data of the
sensor on all the
indoor units*
Initial
setting
ta=A
No.2
The data of the sensor
on the indoor unit that
is connected
with remote controller
ta=A
No.3
The data of the sensor
on main remote
controller
ta=B
OUTDOOR
UNIT
INDOOR
UNIT
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
UNIT
INDOOR
UNIT
REMOTE
(MAIN)
ta=A
ta=A
ta=B
*Since the setting is applied to each indoor unit while branch box is connected, the indoor
unit is controlled based on the sensor data of itself, not the average data.
Function
Settings
Mode No.
Setting No.
: Initial setting
(when sent from the factory)
Remarks
Power failure
automatic recovery
Indoor temperature
detecting
LOSSNAY
connectivity
Power supply
voltage
Frost prevention
temperature
Humidifier control
OFF
ON*
Average data from each indoor unit
Data from the indoor unit with remote controller
Data from main remote controller
Not supported
Supported
(Indoor unit does not intake outdoor air through LOSSNAY
)
Supported
(Indoor unit intakes outdoor air through LOSSNAY)
230V
208V
36°F [2:]
37°F [3:]
When the compressor operates, the humidifier also operates.
When the fan operates, the humidifier also operates.
1
2
1
2
3
1
2
3
1
2
1
2
1
2
01
02
03
04
15
16
The setting can
be made to
each indoor
unit individually.
* After the power supply returns, the indoor unit will not operate for 3 minutes (Some kind of indoor units operate for
30 seconds, after that, it stops for 3 minutes). This is normal operation.
To Next Page
Loading...
