11
START/STOP ENGINE SWITCH
(IF EQUIPPED WITH F.A.S.T.-KEY)
While carrying the F.A.S.T.-KEY within the
operating range, the Start/Stop Engine
Switch can be used to start the engine.
• Move the selector lever in “P” position
and hold the brake pedal down. Push
the Start/Stop Engine Switch.
• To stop the engine, stop the vehicle
completely and move the selector
lever to “P” then press the Start/Stop
Engine Switch.
*If you have to bring the engine to an emergency stop while
driving, press and hold the Start/Stop Engine Switch for 3
seconds or more, or press it quickly 3 times or more.
• If you press the Start/Stop Engine Switch without depressing
the brake pedal, you can change the operation mode in the
order of OFF, ACC, ON, OFF.
* If the engine cannot be started by depressing the brake
pedal, depress the brake pedal more firmly than usual with
the right foot. Then, press the Stop/Start Engine Switch.
• If the engine cannot be started or the operation mode cannot
be changed, check the position of the F.A.S.T.-KEY or the
battery performance of the F.A.S.T.-KEY.
INSTRUMENT PANEL
The Blind Spot Warning (BSW) is a driving aid system that alerts
the driver when another vehicle which may not be visible through
the outside rearview mirror is traveling in the next lane behind
your vehicle. When a vehicle in the next lane is traveling at same
speed or faster in the detection areas, the Blind Spot Warning
light in the corresponding outside rearview mirror will illuminate.
If the turn signal lever is operated to the side where the Blind
Spot Warning light is illuminated, the Blind Spot Warning light will
blink and a buzzer will sound to alert the driver.
Depending on the speed of your vehicle, the Blind Spot Warning
will detect up to approximately 230 feet from your vehicle.
BLIND SPOT WARNING WITH LANE CHANGE ASSIST (BSW)
(IF EQUIPPED)
HEATED SEAT SWITCH (IF EQUIPPED)
POSITION ACTION
HI For quick heating
NEUTRAL Heater off
LO Keeps seat warm
To Next Page
Loading...
Need help?
General
