5
STEERING WHEEL CONTROLS
BLUETOOTH
®
CONTROLS FOR SDA TO MAKE A CALL
SAYING A TELEPHONE NUMBER (IF EQUIPPED)
MAKING A CALL USING A PHONEBOOK NUMBER
For a list of compatible Bluetooth
®
devices, please go to
http://www.mitsubishicars.com/owners
There are 3 ways to make a call: by saying a telephone number, by
using the Bluetooth 2.0 interface's phonebook, and by redialing a
telephone number.
1. Press the Speech button.
2. Say "Dial."
3. After the voice guide says "Number please," say the
telephone number.
4. The voice guide will say "Dialing <number recognized>." The
Bluetooth 2.0 interface will then make the call. When the
confirmation function is on, the system will confirm the
telephone number again. To continue with that number, answer
"Yes." To change the telephone number, answer "No." The system
will say "Number please." then say the telephone number again.
1. Press the SPEECH button.
2. Say "Call" (Note: You must have names stored in the Phonebook
or the voice guide will say "The vehicle phonebook is empty.
Would you like to add a new entry now?")
3. After the voice guide says, "Name please." Say the name you
want to call from those registered in the Phonebook. If there is
only 1 match, the system voice guide will say "Calling <name>"
and will dial the telephone number. If there are 2 or more
matches, the voice guide will say "More than one match was
found, would you like to call <repeats name> ." If that person
is the one you want to call, answer "Yes." If it is not the person,
answer "No." The name of the next matching person will be
mentioned by the voice guide.
A
- SPEECH BUTTON
(IF EQUIPPED)
Change to voice recognition
B
- PICK-UP BUTTON
Answer an incoming call
C
- HANG-UP BUTTON
End a call or voice recognition
Bluetooth is a registered trademark of Bluetooth SIG, Inc.
1. Press the HOME key
2. Touch SETTING, then BLUETOOTH
3. Touch the NEW DEVICES. If the Bluetooth
®
device is permitted to
pair then the SDA system will allow the connection to be made.
4. Go to your phone settings to confirm pairing
If you have paired multiple Bluetooth
®
devices with your SDA
system, the Bluetooth
®
device that connected last will be selected
and will automatically connect when it is detected.
TO SELECT A DIFFERENT DEVICE:
1. Press the HOME key
2. Touch SETTING, then BLUETOOTH
3. Touch the PAIRED DEVICES
4. Touch the “device name” to connect
5. This will complete the selection of the Bluetooth
®
device
BLUETOOTH
®
PAIRING
A
B
C