EasyManua.ls Logo

Mitsubishi Outlander PHEV 2019

Mitsubishi Outlander PHEV 2019
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
When the vehicle is stored at the extremely high temperature or extremely low temperature, the battery
performance can decrease.
Even if the vehicle is not in use, the drive battery may be gradually discharged and the energy stored in the
drive battery will be reduced.
<Precautions in use>
If the vehicle is not used for a long time, check the drive battery meter reading every three months. If the
reading is zero, charge the battery until the reading is shown. Or put the electric motor switch in the READY to
automatically start the engine. Wait until the engine stops. Then, turn off the electric motor switch.
The drive battery is retrieved. When the vehicle is discarded, always contact Mitsubishi Motors Dealer.
SERVICE PLUG
The service plug is installed to the lower place
of the rear centre passenger seat. Remove the
service plug before performing the check and
the maintenance work on the high voltage
components to ensure the job safety, shutting
off the high voltage circuit. Inserting and
pulling the service plug switch installed to the
drive battery turns ON/OFF the service plug
lever.
The service plug switch is integrated in the
service plug.
Service plug
Direction of insertion

Other manuals for Mitsubishi Outlander PHEV 2019

Related product manuals