FINAL STEPS
PRE-DELIVERY INSPECTION
1-22
FINAL STEPS
42. HEADLAMP AIMING
M6011000100116
Check condition for headlamp aiming.
NOTE: For headlamp aiming procedures, refer to the
Workshop Manual for that model.
43. EQUIPMENT
M6011000200180
Check the installation of the various equipment.
1. Trunk room floor mats
2. Spare tyre
3. Jack, jack handle and tool set
44. EXTERIOR AND INTERIOR
M6011000300176
Finally check and clean the exterior and interior.
1. Wash the vehicle to remove all traces of road
grime and other dirt on the vehicle as a result of
new vehicle preparations.
2. Clean exterior and interior glass surface.
3. Remove all protective covers.
4. Remove undercoat overspray, excess window
sealer, and excess weatherstrip adhesive.
5. Verify that the secondary key can not unlock the
glove box and tailgate/boot lid (if so equipped).
6. Remove shipping and inspection stickers.
45. OWNER INSTRUCTIONS
M6011000400054
1. Verify that the owner's manual and service
booklet is in the glove box.
2. Place the spare keys in envelope in the glove box
before delivery.
AC305648
Level surface
Headlamp
Screen
AB
To Next Page
Loading...
Need help?
General
