© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
125 (244)125 (244)
PBV20N2 PBV20N2 Service Service ManualManual
8.8.1 8.8.1 Installing Installing the the traction traction motor motor cablescables
Figure 74. Installing the traction motor cables overviewFigure 74. Installing the traction motor cables overview
1.1. Wire harnessWire harness
2.2. Protective spiralProtective spiral
3.3.
Cable holderCable holder
4.4. Mounting plateMounting plate
5.5. SupportSupport
6.6.
BoltBolt
1.1. Install the cables inside the yellowInstall the cables inside the yellow
protective spiral.protective spiral.
2.2. Stretch the protective spiral to checkStretch the protective spiral to check
that the cables are not twisted that the cables are not twisted insideinside
it.it.
3.3. Secure the wire harness inside theSecure the wire harness inside the
protective spiral so that the bend atprotective spiral so that the bend at
the controller side is the controller side is approximateapproximatelyly
the same as on the the same as on the motor side.motor side.
To Next Page
Loading...
