© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
126 (244)126 (244)
PBV20N2 PBV20N2 Service Service ManualManual
4.4. Install the motor side wires insideInstall the motor side wires inside
the cable holder. Make sure that thethe cable holder. Make sure that the
cables are in the correct order ascables are in the correct order as
shown inshown inFigure 75Figure 75 below.below.
5.5. Install the cable holder and theInstall the cable holder and the
mounting plate to the support,mounting plate to the support,
approximately 10 mm from the cableapproximately 10 mm from the cable
tie.tie.
6.6. Insert Loctite 248 glue to the bolts Insert Loctite 248 glue to the bolts ofof
the cable holder.the cable holder.
7.7.
Install the bolts attaching the cableInstall the bolts attaching the cable
holder to the support and tightenholder to the support and tighten
them so that the distance from thethem so that the distance from the
back of the support to the front ofback of the support to the front of
the mounting plate is 37 mm (seethe mounting plate is 37 mm (see
Figure 75Figure 75 below).below).
Figure 75. Correct order of wires inside the cable holderFigure 75. Correct order of wires inside the cable holder
To Next Page
Loading...
