PBV20N2 PBV20N2 Service Service ManualManual
7.7. In TruckTool, check that the displayed values are acceptable and click "Stop".In TruckTool, check that the displayed values are acceptable and click "Stop".
If the process fails, If the process fails, update the firmware on the controller and try update the firmware on the controller and try again.again.
9.1.2 9.1.2 Acquiring Acquiring the the VACC VACC without without Truck Truck ToolTool
1. 1. During key-oDuring key-on, lower the n, lower the forks and forks and turn the aturn the accelerator forwaccelerator forward at the rd at the same timesame time
and hold the buttons down for 15 seconds.and hold the buttons down for 15 seconds.
The truck enters the accelerator teach-in mode.The truck enters the accelerator teach-in mode.
2. 2. Release Release all all the the buttons.buttons.
3. 3. Teach thTeach the accelee accelerator by rator by turning turning it first fully it first fully forward, then forward, then fully backfully backward.ward.
4. 4. Release Release the the accelerator.accelerator.
5. 5. Press thPress the sae safety bfety button utton to sato save thve the sette settings.ings.
6. 6. Restart Restart the the truck.truck.
9.29.2 Insulation resistance testInsulation resistance test
9.2.1 9.2.1 Test Test voltagevoltage
The insulation resistance of the truck and the trThe insulation resistance of the truck and the traction battery is checked separately. Theaction battery is checked separately. The
test voltage is greater than the nominal voltage but no more than 100 V or three timestest voltage is greater than the nominal voltage but no more than 100 V or three times
the nominal voltage:the nominal voltage:
NOMINAL
NOMINAL VOLTAGE VOLTAGE TEST TEST VOLTAGEVOLTAGE
Up to 24 VUp to 24 V
50 V50 V
Over 36 VOver 36 V
100 V100 V
To Next Page
Loading...
