© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
129 (244)129 (244)
PBV20N2 PBV20N2 Service Service ManualManual
9.2.2 9.2.2 Checking Checking the the insulation insulation testertester
Connect the test probe to the Connect the test probe to the frame of the truck frame of the truck (for example, to a non-painted bolt or(for example, to a non-painted bolt or
bracket) and the other test probe to bracket) and the other test probe to another bolt or bracket. The tester should show aanother bolt or bracket. The tester should show a
zero value.zero value.
Figure 76. Checking the insulation testerFigure 76. Checking the insulation tester
9.2.3 9.2.3 Measuring Measuring the the insulation insulation resistanceresistance
The test is The test is performed with the battery disconnected from the truck. All the performed with the battery disconnected from the truck. All the electricalelectrical
components must be in place.components must be in place.
1. 1. Release the Release the emergency stop emergency stop and and turn the turn the key switch key switch to the to the ON position.ON position.
2. 2. Connect thConnect the test probe test probe to the e to the frame of thframe of the truck (for e truck (for example, to example, to a non-paina non-painted boltted bolt
or bracket) and the other or bracket) and the other test probe to the plus test probe to the plus terminal of the battery connector.terminal of the battery connector.
3. 3. Read Read the the resistance resistance value.value.
4. 4. Measure aMeasure and read nd read the minuthe minus terminal os terminal of the baf the battery connector ttery connector in the sain the same way.me way.
To Next Page
Loading...
