Mitsubishi PBV20N2 - Parameter descriptions; Traction controller

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
144 (244)144 (244)



PBV20N2 PBV20N2 Service Service ManualManual
12
12 Parameter Parameter descriptionsdescriptions
CAUTIONCAUTION
Always use the correct parameter list for Always use the correct parameter list for the specific model you are servicing. The the specific model you are servicing. The latestlatest
parameter lists are available from the manufacturer’s Web site.parameter lists are available from the manufacturer’s Web site.
NOTE: If the truck NOTE: If the truck is equipped with the electrical steering option, the parameteris equipped with the electrical steering option, the parameter
descriptions of the steering controller are available in descriptions of the steering controller are available in sectionsection15.11.9.15.11.9.
12.112.1
Traction controllerTraction controller
Table 6. Main menu, parameter changeTable 6. Main menu, parameter change
PARAMETER DESCRIPTION
PARAMETER DESCRIPTION
Acceleration rampAcceleration ramp
ACCELER. DELAACCELER. DELAYY
This parameter determines the acceleration rate ofThis parameter determines the acceleration rate of
the traction motor in the the traction motor in the standard drive mode.standard drive mode.
Value range:Value range:
•
•
 0.1: Fastest0.1: Fastest
••
 10: Slowest10: Slowest
Acceleration ramp end sAcceleration ramp end smootheningmoothening
STOP SMOOTHSTOP SMOOTH
This parameter controls the smoothness when This parameter controls the smoothness when thethe
direction change ramp is stopped.direction change ramp is stopped.
Value range:Value range:
•
• 3 Hz: Minimum3 Hz: Minimum
•
• 20 Hz: Maximum20 Hz: Maximum
Acceleration smoothenAcceleration smootheninging
ACC SMOOACC SMOOTHTH
This parameter controls the smoothness of theThis parameter controls the smoothness of the
acceleration ramp.acceleration ramp.
Value range:Value range:
•
•
 1: Minimum1: Minimum
••
 5: Maximum5: Maximum
Brake release cutback speedBrake release cutback speed
H&S CUTBACKH&S CUTBACK
This parameter controls the speed reduction whenThis parameter controls the speed reduction when
the brake release is activated.the brake release is activated.
Value range:Value range:
•
•
 10%: Enabled10%: Enabled
•
• 100%: Disabled100%: Disabled
Braking ramp end smootheningBraking ramp end smoothening
STOP BRK SMOOTHSTOP BRK SMOOTH
This parameter controls the smoothness when This parameter controls the smoothness when thethe
braking ramp is stopped.braking ramp is stopped.
Value range:Value range:
•
•
 3 Hz: Minimum3 Hz: Minimum
•
• 20 Hz: Maximum20 Hz: Maximum
https://www.forkliftpdfmanuals.com/