Mitsubishi PBV20N2 - Page 147

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
146 (244)146 (244)



PBV20N2 PBV20N2 Service Service ManualManual
PARAMETER DESCRIPTION
PARAMETER DESCRIPTION
ECO: Release braking rampECO: Release braking ramp
RELEASE BRAK. ERELEASE BRAK. E
This parameter controls the deceleration rate whenThis parameter controls the deceleration rate when
the accelerator is released in the the accelerator is released in the economy driveeconomy drive
mode.mode.
Value range:Value range:
•
•
 0.1: Fastest0.1: Fastest
•
•
 10: Slowest10: Slowest
ECO: Speed limit braking rampECO: Speed limit braking ramp
SPEED LIM BRK. ESPEED LIM BRK. E
This parameter controls the deceleration rate whenThis parameter controls the deceleration rate when
speed reduction is activated in the economy drivespeed reduction is activated in the economy drive
mode.mode.
Value range:Value range:
•
• 0.1: Fastest0.1: Fastest
••
 10: Slowest10: Slowest
ECO: Steering cutback braking rampECO: Steering cutback braking ramp
STEER BRAKING ESTEER BRAKING E
This parameter controls the deceleration rate whenThis parameter controls the deceleration rate when
electrical steering cutback is activated in theelectrical steering cutback is activated in the
economy drive mode.economy drive mode.
Value range:Value range:
•
• 0.1: Fastest0.1: Fastest
•
• 10: Slowest10: Slowest
Inversion braking rampInversion braking ramp
INVERS. BRAKINGINVERS. BRAKING
This parameter controls the deceleration rate whenThis parameter controls the deceleration rate when
the direction switch is reversed while moving in thethe direction switch is reversed while moving in the
standard drive mode.standard drive mode.
Value range:Value range:
•
• 0.1: Fastest0.1: Fastest
•
• 10: Slowest10: Slowest
Inversion smootheningInversion smoothening
INV SMOOTHINV SMOOTH
This parameter controls the smoothness of This parameter controls the smoothness of directiondirection
change during a drive.change during a drive.
Value range:Value range:
•
• 1: Minimum1: Minimum
•
•
 5: Maximum5: Maximum
Max speed forwardMax speed forward
MAX SPEED FORWMAX SPEED FORW
This parameter controls the maximum speedThis parameter controls the maximum speed
forward in the standard drive mode.forward in the standard drive mode.
Value range:Value range:
•
• 10%: Slowest10%: Slowest
•
• 100%: Fastest100%: Fastest
NOTE:NOTE:For safety reasons, do not exceed theFor safety reasons, do not exceed the
parameter table value!parameter table value!
Max speed FWD PIN 3Max speed FWD PIN 3
MAX SP. FW PIN3MAX SP. FW PIN3
Maximum speed forward with PIN code 3.Maximum speed forward with PIN code 3.
Max speed FWD PIN1Max speed FWD PIN1
MAX SP. FW PIN1MAX SP. FW PIN1
Maximum speed forward with PIN code 1.Maximum speed forward with PIN code 1.
https://www.forkliftpdfmanuals.com/