Mitsubishi PBV20N2 - Pressure sensor

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
195 (244)195 (244)



PBV20N2 PBV20N2 Service Service ManualManual
Figure 96. Voltage converter wiring overviewFigure 96. Voltage converter wiring overview
15.615.6
Pressure sensorPressure sensor
The pressure sensor is used for The pressure sensor is used for monitoring the hydraulic pressure of the hydraulicmonitoring the hydraulic pressure of the hydraulic
system. With this sensor, the system. With this sensor, the traction controller can adjust the driving speed accordingtraction controller can adjust the driving speed according
to the lifted load. The to the lifted load. The pressure sensor has an output signal of 1–6 Vdc pressure sensor has an output signal of 1–6 Vdc in the range of 0-in the range of 0-
250 bar oil pressure.250 bar oil pressure.
TypeType
Pressure transmitterPressure transmitter
VV
ss

9 - 30 Vdc9 - 30 Vdc
Output signalOutput signal
1 – 6 VDC / < 5 mA1 – 6 VDC / < 5 mA
Measuring rangeMeasuring range
0 – 250 bar0 – 250 bar
Electrical wiringElectrical wiring
1 = L+ (Supply)1 = L+ (Supply)
2 = OUT (output signal)2 = OUT (output signal)
3 = M (GND)3 = M (GND)
Spare partSpare part
RL469001RL469001
https://www.forkliftpdfmanuals.com/