

© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
56 (244)56 (244)

PBV20N2 PBV20N2 Service Service ManualManual
5.105.10 Load wheelsLoad wheels
Figure 36. Load wheels overviewFigure 36. Load wheels overview
Check the wear of Check the wear of the load wheels:the load wheels:
•
•
 The diameter of a new load wheel is 85 mm.The diameter of a new load wheel is 85 mm.
•
•
 It is recommended that the load wheel is replaced when its diameter reachesIt is recommended that the load wheel is replaced when its diameter reaches
76 mm.76 mm.
NOTE: To access the load wheels, lift NOTE: To access the load wheels, lift up the forks and the truck up the forks and the truck so that the loadso that the load
wheels are off the floor (see the wheels are off the floor (see the correct lifting points in the sectioncorrect lifting points in the section5.15.1 of this manual)of this manual)
and turn the load wheel so that you can access the bolt holding the wheel in place.and turn the load wheel so that you can access the bolt holding the wheel in place.

Disassembly of the load Disassembly of the load wheel:wheel:
1.1.
Remove the bolt holding the loadRemove the bolt holding the load
wheel in the bracket.wheel in the bracket.
2.2. Remove the load wheel from theRemove the load wheel from the
bracket.bracket.
3.3. Check the condition of the slideCheck the condition of the slide
bearing. Replace the part, if bearing. Replace the part, if needed.needed.
4.4. Check the condition of the bracketCheck the condition of the bracket
shafts. Replace the part, if shafts. Replace the part, if needed.needed.
To Next Page
Loading...
