Mitsubishi PBV20N2 - Page 65



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
65 (244)65 (244)

PBV20N2 PBV20N2 Service Service ManualManual
1.1. Remove all the covers. For instructions, see sectionRemove all the covers. For instructions, see section5.4.5.4.
2.2. Remove the tiller arm and the tiller Remove the tiller arm and the tiller arm fastener. For instructions, see sectionarm fastener. For instructions, see section
5.15.5.15.
3.3. Remove the drive unit. For instructions, see sectionRemove the drive unit. For instructions, see section8.3.1.8.3.1.
4.4. Remove the hydraulic cylinder. For Remove the hydraulic cylinder. For instructions, see sectioninstructions, see section10.5.10.5.
5.5. Remove the four screws at the Remove the four screws at the backback
of the motor bed frame.of the motor bed frame.
6.6. Lift the motor bed frame out of itsLift the motor bed frame out of its
slot.slot.
7.7. Remove the screws and shaftsRemove the screws and shafts
holding the drive unit suspensionholding the drive unit suspension
springs in place.springs in place.
8.8. Remove the springs.Remove the springs.
https://www.forkliftpdfmanuals.com/