Mitsubishi S16R-PTA-C - Scheduled Maintenance for Continuous Use Engine; Table 7-3 Scheduled Maintenance for Continuous

7 SCHEDULED MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
122
Pub. No. K29001-00320 Revision: 1
Scheduled Maintenance for Continuous Use Engine
For the continuous use engine, perform the scheduled maintenance in accordance with the following table.
• Conduct the scheduled maintenance at specified intervals, either service hours or service
period, whichever comes first.
*1: If the part is not supplied from Shanghai MHI Engine co., Ltd. (SME), service the part following the
supplier's operation manual.
*2: Replace also the oil filters when the filter alarm lamp is turned on.
*3: Replacing interval of the oil filter can be changed according to the results of engine oil analysis or the
type of oil pan.
Table 7-3 Scheduled Maintenance for Continuous Use Engine (1/3)
Inspection and Maintenance
Period
Service Items
Reference
Page
Service
period
Service hours
Every
month
Every 50
service hours,
• Fuel Tank - Drain Water * 1 141
• Water Separator - Drain Water *1 145
-
First 50 service
hours for a new
or overhauled
engine
• Bolts and Nuts on the Engine - Retighten 91
• Engine Oil, Oil Filter, and Bypass Oil Filter - Replace *2 *3
159
161
161
• Engine Oil - Analysis (Recommended) -
-
Every 250
service hours
• Engine Oil, Oil Filter, and Bypass Oil Filter - Replace * 2*3 159
161
161
• Engine Oil - Analysis (Recommended) -
-
First 250 service
hours for a new
or overhauled
engine
• Valve Clearance - Check and Adjust
(Check the valve mechanism parts at the same time.)
8
(Contact your
SME dealer)
-
Every 1000
service hours
• Fuel Filter - Replace 147
• Water Separator Element - Replace *1 145
• Gauze Filter - Clean 146
• Belt and Belt Tension - Check and Adjust (Replace parts as
needed.)
134
136
-
Every 2000
service hours
• Fuel Tank - Drain Water (Replace parts as needed.) *1 141
• Valve Clearance - Check and Adjust
(Check the valve mechanism parts at the same time.)
• Fuel Injection Timing - Check and Adjust
• Fuel Injection Nozzle Tip, Spacer, and Nozzle Spring -
Replace (Check the spray condition and adjust the fuel
injection pressure after the replacement.)
• Movement of Rack of the Fuel Injection Pump (Including the
Governor) - Check (During Operation)
8
(Contact your
SME dealer)