Notes, Cautions, Warnings, Dangers
Notes, cautions, wamings, dangers are used in this manual to emphasize important or critical instructions or
advice.
(&OANGER)
&WARNING
(&CAUTION)
(NOTE)
'Ierms Used in This
Manual
Indicates the most serious specific potential hazard
resulting in serious bodily injury or death.
Indicates a specific potential hazard resulting in
bodily injury.
Indicates operating procedure, practice, etc.,resulting
in personal injury or damage to or destruction
of
engine.
An operating procedure, condition, etc. that will help
you work more efficiently.
Before you read this manual, note that the following special terms are used in dimensional and otherspecifications.
Assembly Standard Indicates the dimension of a part, the dimension to be attained at the
time of reassembly or the standard performance. The value is rounded
to the nearest whole number needed for inspeetion and is different from
the design value.
Nominal Value Indicates the standard dimension of a part.
Repair Limit.. A part which has reached this limit must be repaired.
Service Limit A part which has reached this limit must be replaced.
Standard Clearance Indicates the clearance to be obtained between mating parts atreassembly.
To Next Page
Loading...
Need help?
General
