(7) Wiring connection
Notes:
1. Remove the negative (-) terminal of the battery.
2. Never interchange battery connections otherwise it will burn or damage the electrical parts.
3. Remove the painting on the frame before connecting the ground terminal.
4. Each wiring should be routed along with the existing harness or piping.
5. Wiring harness should be tied-up with band.
Item 31 & 32 of parts list.
6. Use ø35 hole on the toe board for wiring to pass through.
7. Fix the wire harness firmly in their relative positions with band & clamp to protect from wire damage & sparks
caused by vibration.
– 82 –
To Next Page
Loading...
