Mitsubishi TDJ430D - Page 84

(b) Applicable for Mitsubishi FE, FG vehicles sold since November, '93
Notes:
1. This installation drawing of controller is for Mitsubishi FE, FG which is available after november of '93.
2. Installation procedure
(1) Remove the instrument vessel.
(2) Remove the radio & accessory box with inside panel bracket.
(3) Remove & discard the lower accessory box.
(4) Fix bracket B (TJD116A043) to the inside panel bracket with tapping screw (W010D05X010).
(5) Fix bracket (LH: TJD116A042) & bracket (RH: TJD116A042A) to the controller with tapping screw.
(6) Insert the connector to the controller.
(7) After completing (5) & (6), fix the controller to the inside panel bracket & bracket (B) (TJD116A043) with
tapping screw (W010D05X010).
(8) Fix the radio & controller to the inside panel bracket assembly.
(9) Re-assemble the instrument vessel.
(10) Install the control panel (TJF133A001A) using clip (SSA937C321).
3. For maintenance, just remove the controller & bracket (LH) & (RH) assemblies.
(First, remove clip SSA937C321).
– 84 –