Mitsubishi VS - User Manual

To Next Page

Extron • System 4

xixi

Switcher Series • User’s Manual • P/N 68-401-02 Rev. C

Configuration and Connections

Mitsubishi Installation

Page 1

SYSTEM 4

xixi

PROJECTOR COMMUNICATIONS KIT

ATTENTION!

PLEASE READ THIS DOCUMENT FOR IMPORTANT

INSTALLATION INSTRUCTIONS

THIS KIT HAS BEEN SHIPPED WITH THE FOLLOWING COMPONENTS:

Kit Type: MITSUBISHI

Included Communications Adapter(s):

Quantity Part Number Description

1 26-473-01 ADP, UNV, “E”

1 26-475-01 ADP, UNV, “G”

1 26-458-01 ADP, UNV, “NEC-LCD MT”

THE TABLE BELOW LISTS THE POSSIBLE CONFIGURATION(S) AND CORRESPONDING

COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER’S VARIOUS

MODELS. PLEASE NOTE THAT YOUR SWITCHER HAS BEEN CONFIGURED AS

INDICATED BY THE “✔” IN THE “CONFIG AS” COLUMN. IF YOUR PROJECTOR MODEL

DIFFERS FROM THIS CONFIGURATION, YOU MUST RECONFIGURE YOUR SWITCHER

WITH THE CORRECT SETTINGS.

PLEASE REFER TO THE FOLLOWING PAGES FOR COMPLETE CONFIGURATION AND

SIGNAL CONNECTION INSTRUCTIONS.

THIS SWITCHER HAS BEEN CONFIGURED FOR: MITSUBISHI VS

CONFIG MODEL SW1 SW2 SW3 SW4 SW5 SW6 PROJ COMM

AS 1 2 3 4 CABLE ADAPTER

✔ VS off on off on 0 0 8 5 0 J15 26-473-01

LVP-X100 off on off on 0 0 6 F 0 J15 26-475-01

LVP-X200X300 off on off on 0 1 6 F 0 J15 26-475-01

LVP-X400 off on off on 0 2 6 F 0 J15 26-458-01

Page 1

Need help?

Do you have a question about the Mitsubishi VS and is the answer not in the manual?

Summary

Projector Communications Kit Overview

Kit Components and Configuration Guidance

Lists included communication adapters and provides general configuration notes for projectors.

Connecting System 4 xi to Mitsubishi LVP-X100

Verification and Switch Settings for LVP-X100

Verifies System 4xi setup for LVP-X100 and details internal switch configurations.

System 4 xi LVP-X100 Projector Connections

Illustrates and describes physical cable connections between System 4xi and LVP-X100.

Connecting System 4 xi to Mitsubishi VS Projector

Verification and Switch Settings for VS Projector

Confirms System 4xi setup for VS projector and outlines internal switch configurations.

System 4 xi VS Projector Connections

Provides a connection diagram and details for linking System 4xi to a VS projector.

Connecting System 4 xi to Mitsubishi LVP-X200 Projector

Verification and Switch Settings for LVP-X200

Checks System 4xi configuration for LVP-X200 and details internal switch settings.

System 4 xi LVP-X200 Projector Connections

Illustrates and describes physical cable connections between System 4xi and LVP-X200.