Wiper and washer switch
Instruments and controls 5-49
5
With the lever in the “AUTO” (rain sensor)
position, it is possible to adjust the sensitivity
of the rain sensor by turning the knob (B).
Move the lever in the direction of the arrow
and release, to operate the wipers once.
Use this function when you are driving in
mist or drizzle.
The wipers will operate once if the lever is
raised to the “MIST” position and released
when the operation mode of the power switch
is in ON or ACC. The wipers will continue to
operate while the lever is held in the “MIST”
position.
The wipers will operate once if the lever is
moved to the “AUTO” position and the knob
(C) is turned in the “+” direction when the
operation mode of the power switch is in ON.
• A physical shock is applied to the wind-
screen.
• A physical shock is applied to the rain sen-
sor.
Do not cover the sensor by affixing a sticker
or label to the windscreen. Also, do not put
any water-repellent coating on the wind-
screen. The rain sensor would not be able to
detect the extent of rain, and the wipers
might stop working normally.
In the following cases, the rain sensor may
be malfunctioning.
For further information, please contact your
authorised MITSUBISHI MOTORS dealer.
• When the wipers operate at a constant inter-
val despite changes in the extent of rain.
• When the wipers do not operate even
though it is raining.
The wipers may automatically operate when
things such as insects or foreign objects are
affixed to the windscreen on top of the rain
sensor or when the windscreen is frozen.
Objects affixed to the windscreen will stop
the wipers when the wipers cannot remove
them. To operate the wipers again, move the
lever in the “LO” or “HI” position.
Also, the wipers may operate automatically
due to strong direct sunlight or electromag-
netic wave. To stop the wipers, place the
lever in the “OFF” position.
Contact an authorised MITSUBISHI
MOTORS dealer when replacing the wind-
screen or reinforcing the glass around the
sensor.
To adjust the sensitivity of the rain sen-
sor
“+”- Higher sensitivity to rain
“-”- Lower sensitivity to rain
Automatic operation (rain droplet sensitive)
can be changed to intermittent operation.
For further information, please contact your
authorised MITSUBISHI MOTORS dealer.
Misting function
To Next Page
Loading...
Need help?
General
