Bonnet
10-4 Maintenance
10
E01000305064
1. Pull the release lever towards you to
unlock the bonnet.
2. Raise the bonnet while pressing the safety
lock.
3. Support the bonnet by inserting the sup-
port bar in its slot.
1. Unlatch the support bar and clip it in its
holder.
2. Slowly lower the bonnet to a position
approximately 20 cm above the closed
position, then let it drop.
3. Make sure the bonnet is securely locked
by softly lifting the centre of the bonnet.
Paint should not be applied to the catalytic
converter.
Use fuel of the type recommended in “Fuel
selection” on page 2-10.
Bonnet
To open
Only open the bonnet when the wipers are in
the original position. In any other position,
the wipers could damage the paint or bonnet.
Note that the support bar may disengage the
bonnet if the open bonnet is lifted by a strong
wind.
After inserting the support bar into the slot,
make sure the bar supports the bonnet
securely from falling down on to your head
or body.
To close
To Next Page
Loading...
Need help?
General
