Keys
3-2 Locking and unlocking
3
E00300104973
E00314000180
The key number is stamped on the tag as indi-
cated in the illustration.
Make a record of the key number and store
the key and key number tag in separate
Keys
1- Keyless operation key
2- Emergency key
When taking a key on flights, do not press
any switches on the key while on the
plane. If a switch is pressed on the plane,
the key emits electromagnetic waves,
which could adversely affect the plane’s
flight operation.
When carrying a key in a bag, be careful
that no switches on the key can be easily
pressed by mistake.
The keyless operation key is a precision
electronic part with a built-in signal trans-
mitter. Please observe the following in order
to prevent a malfunction.
• Do not leave anywhere that is exposed to
direct sunlight, for example on the dash-
board.
• Do not disassemble or modify.
• Do not excessively bend the key or subject
it to a strong impact.
• Do not expose to water.
• Keep away from magnetic key rings.
• Keep away from audio systems, personal
computers, TVs, and any other equipment
that generates a magnetic field.
• Keep away from devices that emit strong
electromagnetic waves, such as cellular
phones, wireless devices and high fre-
quency equipment (including medical
devices).
• Do not wash with ultrasonic cleaners or
similar equipment.
• Do not leave the key where it may be
exposed to high temperature or high humid-
ity.
The Hybrid EV System is designed so that it
will not start if the ID code registered in the
immobilizer computer and the key’s ID code
do not match. For details on that and on key
usage, refer to the section entitled “Elec-
tronic immobilizer”.
Pay attention to the following if the security
alarm is set to “Active”.
Refer to “Security alarm system” on page
3-18.
• If the security alarm is in the system armed
mode, the alarm will sound if the doors are
opened after being unlocked with the key,
the inside lock knob or the central door lock
switch.
• Even if the security alarm is set to
“Active”, the system preparation mode is
not entered if the keyless entry system or
the keyless operation function was not used
to lock the vehicle.
If you lose one of the keyless operation keys,
contact an authorised MITSUBISHI
MOTORS dealer as soon as possible.
To obtain a replacement or extra spare key,
take your vehicle and all remaining keys to
an authorised MITSUBISHI MOTORS
dealer.
All the keys have to be re-registered in the
immobilizer computer unit.
It is possible to register up to four keys for
the keyless operation system.
Key number tag
To Next Page
Loading...
Need help?
General
