Active stability control (ASC)
6-38 Starting and driving
6
E00619001185
On slippery surfaces, the traction control
function prevents the drive wheels from spin-
ning excessive, thus helping the vehicle to
start moving from a stopped condition. It also
provides sufficient driving force and steering
performance as the vehicle turns while press-
ing the acceleration pedal.
E00619101173
The stability control function is designed to
help the driver maintain control of the vehicle
on slippery roads or during rapid steering
maneuvers. It works by controlling the motor
and/or the engine output and the brake on
each wheel.
E00623301033
Perform the following steps to turn the ASC
on or off.
1. Press the left switch (A)/right switch (B)
until the function setting display appears
in the multi information screen.
Refer to “Multi information screen (when
the operation mode of the power switch is
ON)” on page 5-9.
2. Operate the Up/Down switch (C) to select
the “Driver Assistance” menu, and then
press the Enter switch (C).
Refer to “Function setting display” on
page 5-11.
3. In the “Driver Assistance” menu, high-
light the “ASC” item and press the Enter
switch (C). This will turn the ASC on or
off.
When the ASC is deactivated, the indica-
tor will turn on. When the ASC is reactivated,
the indicator will turn off.
When the ASC is activated, you may feel a
vibration in the vehicle body or hear a whin-
ing sound from the engine compartment.
This indicates that the system is operating
normally. It does not indicate a malfunction.
When the ABS warning lamp is illuminated,
the ASC is not active.
Traction control function
When driving a vehicle on a snowy or icy
road, be sure to install snow tyres and drive
the vehicle at moderate speeds.
Stability control function
The stability control function operates at
speeds of approximately 15 km/h or higher.
Turning the ASC on/off
1- ASC on
2- ASC off
For safety reasons, stop the vehicle before
turning off the ASC.
To Next Page
Loading...
Need help?
General
