Cruise control
Starting and driving 6-43
6
Depress the brake pedal to decrease the
speed. To return to the previously set speed,
press up the “RES +” switch (C).
Refer to “To resume the set speed” on page
6-44.
E00609703200
Set-speed driving can be deactivated as fol-
lows:
Press the CRUISE CONTROL ON/OFF
switch (A). (Cruise control will be turned
off.)
Press the “CANCEL” switch (D).
Depress the brake pedal.
Set-speed driving is deactivated automati-
cally in any of the following ways.
When your speed slows to approximately
15km/h or more below the set speed
because of a hill, etc.
When your speed slows to approximately
30 km/h or less.
When the active stability control (ASC)
starts operating.
Refer to “Active stability control (ASC)”
on page 6-37.
In some driving conditions, set-speed driving
may be deactivated. If this happens, refer to
“To activate” on page 6-41 and repeat the
speed setting procedure.
To temporarily decrease the speed
To deactivate
Although set-speed driving will be deacti-
vated when shifting to the “N” (NEU-
TRAL) position, never put the select
position in the “N” (NEUTRAL) position
while driving.
You would have no regenerative braking
and could cause a serious accident.
When set-speed driving is deactivated auto-
matically in any situation other than those
listed above, there may be a system malfunc-
tion.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by an authorised
MITSUBISHI MOTORS dealer.
To Next Page
Loading...
Need help?
General
