Head restraints
Seat and seat belts 4-9
4
Lift the head restraint with the height adjust-
ing knob (A) pressed in.
Confirm that the head restraint is facing the
correct direction, and then insert it into the
seatback while pressing the height adjusting
knob (A) in the direction indicated by the
arrow.
The head restraint stalk with the adjustment
notches (B) must be installed in the hole with
the adjusting knob (A).
When a person sits in the second or the
third seats, pull up the head restraint to a
height at which it locks in position. Be
sure to make this adjustment before start-
ing to drive. Serious injuries could other-
wise be suffered in the result of an impact.
The head restraints of the third seats cannot
be removed.
To remove (front or second
seats)
To install (front or second
seats)
Confirm that the height adjusting knob (A) is
correctly adjusted as shown in the illustra-
tion, and also lift the head restraints to
ensure that they do not come out of the seat-
back.
The shape and size of the head restraint dif-
fers according to the seat. Always use the
correct head restraint provided for the seat
and do not install the head restraint in the
wrong direction.
To Next Page
Loading...
Need help?
General
