Instruments
Instruments and controls 5-3
5
Pay careful attention to the engine coolant
temperature display while you are driving.
E00573700063
This displays the amount of fuel remaining.
E00573800107
When the fuel is reduced to approximately
6 litres, the information screen switches to the
interrupt display of the fuel remaining warn-
ing display, and the “ ” mark (B) on the fuel
remaining display flashes slowly (approxi-
mately once per second). After a few seconds,
the information screen returns from the fuel
remaining warning display to the previous
screen.
If the remaining fuel level is reduced further,
the information screen switches to the fuel
remaining warning display and the “ ” mark
(B) on the fuel remaining display flashes
quickly (approximately twice per second).
If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures.
Refer to “Engine overheating” on page 8-5.
Fuel remaining display
1- Full
0- Empty
It may take several seconds to stabilise the
display after refilling the tank.
If fuel is added when the operation mode of
the power switch is ON, the fuel gauge may
incorrectly indicate the fuel level.
The arrow (A) indicates that the fuel tank
filler is located on the left side of the vehicle.
Fuel remaining warning display
If the warning display appears, refuel imme-
diately.
Do not repeatedly start and stop the Hybrid
EV System. In order to protect the drive bat-
tery, the Hybrid EV System may become
unable to start. If the Hybrid EV System can-
not be started even after refuelling, please
contact an authorised MITSUBISHI
MOTORS dealer.
On inclines or curves, the display may be
incorrect due to the movement of fuel in the
tank.
To Next Page
Loading...
Need help?
General
