Need help?Do you have a question about the µ-Dimension SST 1200es and is the answer not in the manual?
General| Build Volume | 120 x 120 x 120 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Heated Bed | Yes |
| Nozzle Temperature | Up to 260°C |
| Connectivity | USB, SD Card |
| Supported Materials | PLA, ABS, PETG, TPU |
Locate additional resources like manuals, online help, and web resources for the Dimension system.
Step-by-step instructions for installing and setting up the Dimension 3D printer system.
Guidance on operating the Dimension 3D printer and its associated software, CatalystEX.
List of all replaceable supplies and parts used with the Dimension 1200es modeling system.
Guidelines for placing the Dimension printer in its optimal operating location and environment.
Recommended procedures for unpacking and preparing the Dimension printer for its initial use.
Instructions for placing covers over forklift channels after printer installation.
Procedure for preparing and connecting all necessary power cables for the Dimension printer.
Steps to safely power on the Dimension 3D printer and its boot-up process.
Guidance on correctly installing the modeling base onto the Z Platform for printing.
Instructions for installing the CatalystEX preprocessing software on your PC.
Procedures for establishing communication between your PC and the Dimension printer via network.
Steps for connecting the Dimension printer directly to a PC without using a network.
Overview of the Dimension printer's main user interface, including the display panel and keypad.
Instructions for inserting the modeling base, including precautions for material buildup.
Procedure for safely powering down the Dimension printer system.
Steps to remove all power from the Dimension system and restart it.
Detailed steps for loading material cartridges into the Dimension printer.
Instructions on how to unload and replace model and support material cartridges.
Guidance on building preloaded test parts to familiarize with the Dimension system.
Procedures for sending and building parts from your own CAD files.
Instructions for creating an STL file and sending it to the Dimension printer via CatalystEX.
Explanation of printer status messages and material levels shown on the display panel during a build.
How to control and toggle the chamber lights on and off through the display panel.
Procedure for pausing the print operation, e.g., for material cartridge replacement.
Steps to resume building a part after it has been paused.
How the printer returns to Idle mode from Standby mode.
Instructions on how to cancel a print job at any time during the building process.
Steps to safely remove a completed part from the Dimension printer and modeling base.
Procedures for removing breakaway and soluble support materials from printed parts.
List of tools provided in the Dimension Startup Kit for system maintenance.
Procedure for emptying the purge container to maintain part quality.
Instructions for cleaning the fan filter to ensure proper system operation.
Steps for replacing the brush/flicker assembly after 500 hours of operation.
Cleaning and lubricating of the printer's Z, X, and Y axis lead screws and guide rods.
Procedure for replacing liquefier tips at approximately 2000 operating hours.
Instructions for removing material buildup on the Z Platform and lead screw.
Procedure for vacuuming the build chamber to remove foreign particles.
Method for cleaning the Dimension printer's door glass.
Information on replacing the chamber light bar when it burns out.
Procedure for cleaning material buildup behind the extrusion tips.
Steps for replacing torn or damaged tip shrouds to maintain model quality.
A guide to diagnosing and resolving common problems and error messages with the Dimension printer.
Information on error codes displayed by the Dimension printer and their meanings.
Diagnosing and identifying issues related to material not extruding from the printer head.
Procedure to recover from a loss of extrusion event in the Dimension printer.
Understanding the causes and effects of a clogged liquefier tip on the Dimension printer.
Step-by-step instructions for clearing a clogged liquefier tip on the Dimension printer.
To Next Page
