MMC D-2401-2 - Page 35

STANDARDS ASSOCIATION OF AUSTRALIA
Incorporated by Royal Charter STANDARDS
HOUSE, 80 ARTHUR STREET, NORTH SYDNEY, N.S.W.
EXPLOSION PROTECTED ELECTRICAL EQUIPMENT
CERTIFICATE OF COMPLIANCE
Certificate Number: Ex 973
This certificate is issued for the electrical equipment:
Ullage Interface Temperature Probe Model D-2401-2
Submitted for Certification by: MMC International Corporation
60 Inip Drive INWOOD L.I. NEW
YORK 11696 USA
and Manufactured by; MMC International Corporation
This electrical equipment and any acceptable variation thereto is specified in the
Schedule or Schedules attached hereto and in the documents referred to therein.
This certifies that the equipment described has been found to comply with
AS 2380.7-1987.
TYPE OF PROTECTION: Ex ia IIB T5 Zone 0
This certificate is granted subject to the conditions as set out in Standards
Australia Miscellaneous Publication MP42 and any additional conditions as may be
prescribed by Standards Australia.
Test Report No; FM: J.I. OP3QO.AX
File: P/3: 88121/M145
Date of Issue; 11 January 1989
Remarks; This page Is re-issued to correct an omission in the description of the
equipment.
Page 1 of 2 (Issue 2)
This document shall not be reproduced except in full.
This certificate remains the property of the Standards Association of
Australia and must be returned to the Association in the event of it being
revoked.
P31
Director—Administration & Approvals
Standards Association of Australia