MOA PerfectFry PFS5 - Using the Appliance; Preparation and Basic Operation

PerfectFry - English manual 6
EN
USING THE APPLIANCE (1/3)
Preparing for use
1. Place the appliance on a stable, horizontal, and heat-resistant
surface.
2. Place the crisper rack in the frying tray properly.
Do not ll the frying tray with oil or any other liquid.
Do not put anything on top of the appliance. This disrupts the airow
and affects the air-frying result.
Power On and Adjusting Temperature/Time:
• Plug in the device. It will be in standby mode.
• Press the ON/OFF button. The default temperature and time for
the program are 180°C and 15 minutes, respectively.
• You can adjust the time and temperature freely by using the Time
+/- and Temperature +/- buttons.
• To cook different foods, you can also press any function icon.
When you press a function icon, the lights will icker. Then press
START/PAUSE to start the unit.
• Each function has its own default time and temperature, which
are listed in the table. You can adjust these values using the Time
+/- and Temperature +/- buttons.
Temperature Control:
• The temperature can be adjusted within the range of 50-200°C.
• Each click on the + / - temperature buttons will increase or reduce
the temperature by 10°C.
• When the temperature reaches 200°C and you press the “+”, it
will loop back to a temperature of 50°C. Similarly, pressing the
“-” at 50°C will cycle back to 200°C.
• During the temperature control process, the temperature digital
display will icker on the screen (not ash during operation). After
ickering three times, the temperature setting is complete.
Time Adjustment:
• The time can be adjusted within the range of 1 to 60 minutes.
• Each click on the + / - time buttons will increase or reduce the
time by 1 minute.
• When the time reaches 60 minutes and you press “+”, the time
will cycle back to 1 minute. Likewise, pressing “-” at 1 minute will
cycle back to 60 minutes.
• During the time control process, the time digital display will icker
on the screen (not ash during operation). After ickering three
times, the time setting is complete.